This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
quantified_home [2011/10/27 16:15] – herman | quantified_home [2018/12/30 00:13] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 3: | Line 3: | ||
* This [[http:// | * This [[http:// | ||
- | ===== Plan ===== | + | ===== Pictures and current status ===== |
+ | The base module is internet connected and logs it's data to[[http:// | ||
+ | ==== Base module ==== | ||
+ | Built the base module with 1 arduino Uno, 1 Ethernet Shield and 1 LCD display. It has 2 temperature sensors (KTY and [[1Wire]]) and 1 light sensor. There is a Mic connected for sound level recording but it's not yet read by software. Data is received with an rf433 receiver connected to pin2 (hardware interrupt). (The yellow wire is the antenna)\\ | ||
+ | {{: | ||
+ | |||
+ | ==== Node (wireless) ==== | ||
+ | The node is 1 Arduino Pro 328 and 1 Seeed Solar charger shield. 1 1Wire temperature sensor for now. It has 2 solar panels connected, one using USB and one direct. So far it runs 24/7 on the full battery and only solar charge. Data is sent using a rf433 transmitter.\\ | ||
+ | {{: | ||
+ | {{: | ||
+ | |||
+ | ===== Plan 1 (done) | ||
- < | - < | ||
* Arduino & Ethernet Shield are ordered at floris.cc | * Arduino & Ethernet Shield are ordered at floris.cc | ||
Line 11: | Line 22: | ||
- < | - < | ||
- < | - < | ||
- | - Connect the 1wire stuff to Arduino. | + | - <del>Connect the 1wire stuff to Arduino.</ |
+ | - It works! | ||
+ | |||
===== Other stuff ===== | ===== Other stuff ===== | ||
* Connected a photoresistor using [[http:// | * Connected a photoresistor using [[http:// | ||
Line 17: | Line 31: | ||
* For calibrating the temp sensor: [[http:// | * For calibrating the temp sensor: [[http:// | ||
* Nice meters: [[http:// | * Nice meters: [[http:// | ||
- | + | * DIY Water meter: | |
- | ===== Pictures and current status ===== | + | * Nice sensors on a break-out board [[http:// |
- | ==== Base module ==== | + | |
- | Built the base module with 1 arduino Uno, 1 Ethernet Shield and 1 LCD display. It has 2 temperature sensors (KTY and [[1Wire]]) and 1 light sensor. There is a Mic connected for sound level recording but it' | + | |
- | {{:quantified_home.jpg? | + | |
- | + | ||
- | ==== Node (wireless) ==== | + | |
- | The node is 1 Arduino Pro 328 and 1 Seeed Solar charger shield. 1 1Wire temperature sensor for now. It has 2 solar panels connected, one using USB and one direct. So far it runs 24/7 on the full battery and only solar charge. Data is sent using a rf433 transmitter.\\ | + | |
- | {{: | + | |
- | {{: | + |